1, the
Submersible pump should work at the design point. The axial force is moderate at this time. The pump has the highest efficiency. The most economical and reliable.
2 and submersible pumps must be checked once every 8 hours. There is no change in each instrument. Whether the circuit node is hot or not. The sound is normal. Whether the normal working current is greater than the rated value of the
motor brand.
Note that one of the following situations should be stopped immediately.
1) the working current of the pump suddenly rises higher than the rated current of the motor.
2) the water output is not normal, and the gap water is water. The amount of sediment is increased.
3) the electrical insulation resistance of the motor is lower than that of 0.5 MEG.
4) the unit has a significant noise shock.
5) power grid voltage is insufficient. Lower than the rated voltage 5%.
6) the fuse burns a phase.
7) damage to the water pipeline.
(4)
stop pump Before the submersible pump is shut down. To prevent the reflux of water. Turn off the valve while
cutting off the power. Restart the time for more than 20 minutes.
(5) use and install the electric leakage protector.
As far as possible, 2 and outlet pipes should not be bent to find and repair the rupture of the water pipe in time to reduce power loss.
3, add more filters to the source water.
4, correct the positive and negative pole of the power before starting, so as not to
reverse the pump.
5, when abnormal conditions are found in use, cut off the power supply in time and make sure that the situation can resume until work is resumed.
Product Categories : Water-submersible Pump